Figure162.Openbezel
Step3.Removetheairbaffle(see“Removingtheairbaffle”onpage189).
Step4.Removethefancageassembly(see“Removingthefancageassembly”onpage272).
Step5.Touchthestatic-protectivepackagethatcontainstheharddiskdrivebackplanetoanyunpainted
metalsurfaceontheserver;then,removethebackplanefromthepackage.
Step6.Positionthe2.5-inchharddiskdrivebackplaneinthedrive-cageretentiontabs;then,rotatethetop
ofthebackplanetowardthelocatorpinsuntilthelatchesclickintoplace.
Figure163.Positionthe2.5-inchHDDbackplane
Step7.Connectthepower,signal,andconfigurationcablestothe2.5-inchharddiskdrivebackplane(see
“Harddiskdrivebackplaneconnectors”onpage33
and“Internalcableroutingandconnectors”on
page312).
Chapter6.Removingandreplacingcomponents247
To Next Page
Loading...
