Hazardousvoltage,current,andenergylevelsarepresentinsideanycomponentthathasthislabel
attached.Therearenoserviceablepartsinsidethesecomponents.Ifyoususpectaproblemwith
oneoftheseparts,contactaservicetechnician.
Readthesafetyinformationin“Safety”onpagev
and“Installationguidelines”onpage35.
Attention:Staticelectricitythatisreleasedtointernalservercomponentswhentheserverispowered-on
mightcausetheservertohalt,whichmightresultinthelossofdata.Toavoidthispotentialproblem,
alwaysuseanelectrostatic-dischargewriststraporothergroundingsystemwhenyouworkinsidethe
serverwiththepoweron.
Toinstallahot-swappowersupply,completethefollowingsteps.
Note:Youmustinstallthefancageassemblybeforeremovingorinstallingthepowersupply.
Step1.Touchthestatic-protectivepackagethatcontainsthehot-swappowersupplytoanyunpainted
metalsurfaceontheserver;then,removethepowersupplyfromthepackageandplaceiton
astatic-protectivesurface.
Step2.Removethepower-supplyfillerpanelfromthepowerbay,ifoneisinstalled.
Hot-swap
power supply
Release
latch
Hot-swap
power-supply
filler panel
Power supply 1
Power supply 2
Figure173.Power-supplyfillerpanelremoval
Step3.Installthepowersupplyandpushitinuntilitlocksintoplace.
Chapter6.Removingandreplacingcomponents257
To Next Page
Loading...
