Lenovo ThinkSystem ST650 V2 - Install a Flash Power Module

• YouTube: https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku: https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1. Remove the server cover. See “Remove the server cover” on page 188.
Step 2. Disconnect the cable of the flash power module from the RAID adapter.
Step 3. Remove the flash power module.
Figure 64. Flash power module removal
a.
Gently pivot the retaining clip as shown.
b.
Lift the flash power module up and remove it from the holder.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a flash power module
Use this information to install a flash power module.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read “Installation guidelines” on page 57 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
100 ThinkSystem ST650 V2 Maintenance Manual