e. Remove all the fans. See “Remove a hot-swap fan” on page 93.
f. Remove the fan cage. See “Remove the fan cage assembly” on page 95.
g. Remove the front door. See “Remove the front door” on page 107.
h. Remove the front bezel. See “Remove the front bezel” on page 105.
Step 2. Locate the front panel board assembly and disconnect the cables from the system board; then,
remove the cable from the cable clips. See “Front panel cable routing” on page 48.
Step 3. Remove the front panel board assembly .
Figure 76. Front panel board assembly removal
a.
Press the release tab in the direction as shown.
b.
Pivot the front panel board assembly outwards; then, pull the cables out to completely
remove the front panel board assembly from the chassis.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the front panel board assembly
Use this information to install the front panel board assembly.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
Chapter 4. Hardware replacement procedures 111
To Next Page
Loading...
