Lenovo ThinkSystem ST650 V2 - Expansion Drive Cage Replacement; Remove the Expansion Drive Cage

Figure 56. Left EIA bracket installation
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 206.
Expansion drive cage replacement
Use this information to remove and install the expansion drive cage.
Note: This section applies only to server models that have the expansion drive cage installed.
Remove the expansion drive cage
Use this information to remove the expansion drive cage.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read “Installation guidelines” on page 57 to ensure that you work safely.
90
ThinkSystem ST650 V2 Maintenance Manual