Step 2. Align the two screw holes in the drive with the corresponding holes in the drive adapter; then, install
the two screws to secure the drive to the drive adapter.
Figure 39. 2.5-inch drive installation to drive adapter
Step 3. Position the drive adapter with the drive into the 3.5-inch drive tray. Align the screw holes in the
drive adapter and the drive with the corresponding holes in the tray; then, install the five screws to
secure the drive adapter and the drive into the tray.
Figure 40. Installing the screws that secure the 2.5-inch drive and the drive adapter
Step 4. Slide the tray with the drive into the drive bay from the front until it snaps into position and then
completely close the handle. See “Install a simple-swap drive” on page 81 or “Install a hot-swap
drive” on page 84.
After you finish
1. Install other drives if necessary.
2. Close the front door; then, use the key to lock the server cover.
3. Complete the parts replacement. See “Complete the parts replacement” on page 206.
3.5-inch hot-swap drive backplane replacement
Use this information to remove and install a 3.5-inch hot-swap drive backplane.
Note: This topic applies only to server models that have 3.5-inch hot-swap drive backplanes installed.
66
ThinkSystem ST650 V2 Maintenance Manual
To Next Page
Loading...
