Lenovo ThinkSystem ST650 V2 - Page 122

• Read “Installation guidelines” on page 57 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku: https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1. Route the cables through the corresponding hole in the chassis.
Step 2. Install the front panel board assembly.
Figure 77. Front panel board assembly installation
a.
Align the tab on the top side of the front panel board assembly with the side of the
corresponding hole in the chassis.
b.
Pivot the front panel board assembly in until it snaps into position.
Step 3. Carefully route the cable from the secured front panel along the cable clips and connect the cables
to the corresponding connectors on the system board. See “Front panel cable routing” on page 48.
After you finish
1. Reinstall the front bezel. See “Install the front bezel” on page 106.
2. Reinstall the front door. See “Install the front door” on page 109.
3. Reinstall the fan cage. See “Install the fan cage assembly” on page 97.
4. Reinstall all the fans. See “Install a hot-swap fan” on page 94.
5. Reinstall all the full-length GPU adapters. See “Install a full-length GPU adapter” on page 114.
6. Reinstall the air baffle. See “Install the air baffle” on page 74.
7. Reinstall all the flash power modules. See “Install a flash power module” on page 100.
8. Reinstall the server cover. See “Install the server cover” on page 190.
9. Complete the parts replacement. See “Complete the parts replacement” on page 206.
112
ThinkSystem ST650 V2 Maintenance Manual