1. Install a new optical drive, tape drive, or filler to cover the drive bay. See “Install an optical drive or a tape
drive” on page 150. To install a filler, complete the following steps:
a. Insert the filler to the vacant drive bay.
Figure 109. Drive bay filler installation
b. Install the cover of the drive bay filler to the front bezel. Then, install the front bezel to the chassis.
Figure 110. Drive bay filler cover installation
2. Remove the retainer from the removed optical drive or tape drive, and then install the retainer to the
chassis.
Chapter 4. Hardware replacement procedures 149
To Next Page
Loading...
