• Depending on the specific type, your PCIe adapter might look different from the illustration in this topic.
• Use any documentation that comes with the PCIe adapter and follow those instructions in addition to the
instructions in this topic.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku: https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1. Locate the applicable PCIe slot. See “Specifications” on page 1 to identify the different types of
PCIe slots in your server.
Note: Ensure that you observe the installation rules and sequence in “Technical rules for PCIe
adapters” in the ThinkSystem ST650 V2 Setup Guide.
Step 2. If a bracket is installed in the PCIe slot, remove it. Store the bracket for the PCIe slot in case that
you later remove the PCIe adapter and need the bracket to cover the place.
Step 3. Install the PCIe adapter.
Figure 128. PCIe adapter installation
Note: Make sure the PCIe adapter retainer is in the opened position.
a.
Align the PCIe adapter to the PCIe slot; then, gently press both ends of the PCIe adapter
until it is securely seated in the PCIe slot.
b.
Close the PCIe adapter retainer.
Step 4. Depending on the type of PCIe adapter, you might need to connect one or more cables. Refer to
the documentation that comes with the PCIe adapter for specific information.
After you finish
1. If you have installed a T4 GPU adapter, install a T4 filler onto the server cover. See “Install a T4 filler” on
page 204.
2. Reinstall the air baffle. See “Install the air baffle” on page 74.
3. Reinstall all the flash power modules. See “Install a flash power module” on page 100.
4. Reinstall the server cover. See “Install the server cover” on page 190.
Chapter 4. Hardware replacement procedures 165
To Next Page
Loading...
