Lenovo ThinkSystem ST650 V2 - Page 192

Figure 140. Separating a processor from the heat sink and carrier
Note: Do not touch the contacts on the processor.
a.
Lift the handle to release the processor from the carrier.
b.
Hold the processor by its edges; then, lift the processor from the heat sink and carrier.
c.
Without putting the processor down, wipe the thermal grease from the top of the processor
with an alcohol cleaning pad; then, place the processor on a static protective surface with the
processor-contact side up.
Step 2. Separate the processor carrier from the heat sink.
Figure 141. Separating a processor carrier the from heat sink
Note: The processor carrier will be discarded and replaced with a new one.
a.
Release the retaining clips from the heat sink.
182
ThinkSystem ST650 V2 Maintenance Manual