Figure 143. PHM components
1 Heat sink
9 Clips to secure processor in carrier
2 Processor identification label
10 Carrier triangular mark
3 Heat sink triangular mark 11 Processor ejector handle
4 Nut and wire bail retainer 12 Processor heat spreader
5 Torx T30 nut 13 Thermal grease
6 Anti-tilt wire bail 14 Processor contacts
7 Processor carrier 15 Processor triangular mark
8 Clips to secure carrier to heat sink
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku: https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1. If you are replacing a processor and reusing the heat sink.
a. Remove the processor identification label from the heat sink and replace it with the new label
that comes with the replacement processor.
b. If there is any old thermal grease on the heat sink, wipe the thermal grease from the bottom of
the heat sink with an alcohol cleaning pad.
Step 2. If you are replacing a heat sink and reusing the processor.
Chapter 4. Hardware replacement procedures 185
To Next Page
Loading...
