Server models with twelve 3.5-inch simple-swap drive bays
Figure 4. Front view of server models with twelve 3.5-inch simple-swap drive bays
Table 3. Components on server models with twelve 3.5-inch simple-swap drive bays
1 Front panel 4 3.5-inch simple-swap drive bays 4-7
2 Optical-drive bays 1-2
5 3.5-inch simple-swap drive bays 0-3
3 3.5-inch simple-swap drive bays 8-11 6 Foot stands
1 Front panel
For information about the controls, connectors, and status LEDs on the front panel, see “Front panel” on
page 21.
2 Optical-drive bays 1-2
Depending on the model, your server might come with an optical drive installed in the lower 5.25-inch
optical-drive bay. The upper 5.25-inch optical-drive bay is for a secondary optical drive or a tape drive. Some
models have a secondary optical drive or a tape drive installed.
3 4 5 3.5-inch simple-swap drive bays
The drive bays are used to install 3.5-inch simple-swap drives. When you install drives, follow the order of the
drive bay numbers. The EMI integrity and cooling of the server are protected by having all drive bays
occupied. The vacant drive bays must be occupied by drive bay fillers or drive fillers.
6 Foot stands
For tower form factor models, the foot stands help the server stand steadily.
Chapter 2. Server components 17
To Next Page
Loading...
