Location of the external LCD diagnostics handset
Location Callouts
The external LCD diagnostics handset is connected to the
server with an external cable.
1 External LCD diagnostics handset
2 Magnetic bottom
With this component, the diagnostic handset can be
attached to the top or side of the rack or chassis with
hands spared for service tasks.
3 External diagnostics connector
This connector is located on the rear of the server, and is
used to connect an external LCD diagnostics handset.
Note: When unplugging the external handset, see the following instructions:
Press the plastic clip on the plug forward.
Hold the clip and remove the cable from the connector.
Display panel overview
The diagnostics device consists of an LCD display and 5 navigation buttons.
28
ThinkSystem ST650 V2 Maintenance Manual
To Next Page
Loading...
