Lenovo x3550 M5 - Removing a USB Embedded Hypervisor Flash Device

SAS/SATA power cable
SAS/SATA power
connector
SAS/SATA signal
cable
Figure139.4x3.5-inchsimple-swapbackplateassemblycableconnection
Step4.Reinstalltheharddiskdrivesandfillerpanels(see“Replacingsimple-swapharddiskdrives”on
page138).
Step5.Reinstallthecover(see“Replacingthecover”onpage120).
Step6.Slidetheserverintotherack.
Step7.Reconnectthepowercordsandanycablesthatyouremoved.
Step8.Turnontheperipheraldevicesandtheserver.
RemovingaUSBembeddedhypervisorflashdevice
UsethisinformationtoremoveaUSBembeddedhypervisorflashdevice.
ToremoveaUSBhypervisorflashdevice,completethefollowingsteps:
Step1.Readthesafetyinformationthatbeginson“Safety”onpagevand“Installationguidelines”on
page116.
Step2.Turnofftheserverandperipheraldevicesanddisconnectthepowercords.
Step3.Removethecover(see“Removingthecover”onpage119).
Step4.Grasptheflashdeviceandpulltoremoveitfromtheconnector.
Chapter5.Removingandreplacingcomponents221