Lenovo x3550 M5 - Removing a PCI Riser-Card Assembly

Step1.Readthesafetyinformationthatbeginson“Safety”onpagevand“Installationguidelines”on
page116
.
Step2.Turnofftheserver,anddisconnectallpowercordsandexternalcables.
Step3.Removethecover(see“Removingthecover”onpage119).
Step4.RemovePCIriser-cardassembly2(see“RemovingaPCIriser-cardassembly”onpage169).
Step5.InserttheSDcardsintotheSDadapter.
Step6.AligntheSDadapterwiththealignmentpinsandconnector;then,pushdownwardsuntilit
isfirmlyseated.
Step7.Fastenthetwoscrews.
Alignment Pin
Connector
1
SD Adapter
3
4
4
SD 1
SD 2
Figure88.SDadapterinstallation
Step8.Reconnectthepowercordsandanycablesthatyouremoved.
Step9.Reinstallthecover(see“Replacingthecover”onpage120).
Step10.Slidetheserverintotherack.
Step11.Seethehttp://www.ibm.com/support/entry/portal/docdisplay?lndocid=MIGR-5096845,that
comeswiththeoption,forinformationabouthowtoconfiguretheSDadapter.
Step12.Turnontheperipheraldevicesandtheserver.
RemovingaPCIriser-cardassembly
UsethisinformationtoremoveaPCIriser-cardassembly.
Note:PCIriser-cardbracketsmustbeinstalledevenifyoudonotinstallanadapter.
ToremoveaPCIriser-cardassembly,completethefollowingsteps:
Step1.Readthesafetyinformationthatbeginson“Safety”onpagevand“Installationguidelines”on
page116
.
Step2.Turnofftheserverandperipheraldevicesanddisconnectthepowercordsandallexternalcables.
Step3.Removethecover(see“Removingthecover”onpage119).
Chapter5.Removingandreplacingcomponents169