Electrical installation − HighLine/StateLine version
Installation according to EMC (installation of a CE−typical drive system)
Wiring
6
83
EDS84DPS424 EN 5.0
6.4.4 Wiring
Notes on the laying of cables:
ƒ In the case of greater cable lengths, a greater cable distance between the cables is
required.
ƒ In the case of parallel routing (cable trays) of cables with different types of signals,
the degree of interference can be minimised by using a metallic cable separator or
isolated cable ducts.
Cover
Barrier without
opening
Power cables
Signal cables
EMVallg001
Fig. 6−3 Cable routing in the cable duct with barrier
Cover
Communication cables
Cable duct
Measuring cables
Analog cables
Control cables
Power cables
EMVallg002
Fig. 6−4 Cable routing in separated cable ducts
To Next Page
Loading...
