Diagnostics
Display of operating data, diagnostics
Drive diagnostics
10
170
EDS84DPS424 EN 5.0
10.1.5 Drive diagnostics
The controller measures relevant operating parameters which can be displayed using the
diagnosis terminal or the PC.
Display of the controller status on the keypad
– If the keypad at the front of the controller is connected to the
diagnostic interface X6, the area of the LCD displays the
controller status via different symbols.
Icon Meaning Note
Controller is switched on. "SwitchedON" state
Controller is enabled.
Application in the controller is stopped.
Quick stop is active.
Controller is inhibited. The power outputs are inhibited.
Controller is ready to start "ReadyToSwitchOn" state
Speed controller 1 in the limitation The drive is torque−controlled.
The set current limit is exceeded in motor
or generator mode
Pulse inhibit is active The power outputs are inhibited.
System fault is active
Fault "Fault" state
Trouble "Trouble" state
TroubleQSP "TroubleQSP" state
Warning is active "Warning" status display
To Next Page
Loading...
