DSS-1000 User Manual
51
Obtaining the IP Address Automatically
If your network has a DHCP server, DSS-1000 will automatically be assigned an IP address.
However, in case DSS-1000 does not detect the DHCP connection, perform the following
procedures to obtain the IP address:
1. On the Setup screen, click Network > Network Connection.
2. On Connection Type, select DHCP.
3. Leave the default DNS Setting as “Auto”.
4. Click Save. Connection is complete when LAN shows “Activated”.
Configuring Port Mapping
By default, DSS-1000 port number is 80. To change this value, click Network > Port Mapping
on the Setup screen.
To Next Page
Loading...
