DSS-1000 User Manual
61
Modifying Camera Settings
In some cases, you may need to modify the camera connection and streaming properties. To
do this, follow the procedures below:
1. On the Setup screen, click Camera.
2. Select the camera from the Camera List panel.
3. Click Get Camera Settings.
4. To modify the connection properties, click the Basic tab. Modify the Name, IP Address,
HTTP Port (port used by remote IE clients), User Name and Password, as needed.
NOTE: The Name is the camera name displayed on DSS-1000. This name is not saved or
shown on the camera side. The maximum length is 32 alphanumeric characters, symbols
are not allowed. In case of a space in between the characters, DSS-1000 automatically
removes that space.
5. To modify streaming properties, click the Camera Settings tab, and modify the settings.
To Next Page
Loading...
