Chapter 6 Network parameters
http://www.level1.com Page 31
IP address: Sets the LAN IP addresses, and the first IP address is 192.168.1.1 by default,
while the other three IP addresses are 0.0.0.0 by default.
Subnet mask: Sets the subnet mask of the corresponding IP address, which is 255.255.255.0
by default.
MAC address: The MAC address of the LAN port. It is suggested not to modify the MAC
address of the LAN port freely.
Interface mode: Sets the duplex mode and rate for interfaces. Options are: Auto (adaptive),
10M-FD (10M full duplex), 10M-HD (10M half duplex), 100M-FD (100M full duplex),
100M-HD (100M half duplex), 1000M-FD (1000M full duplex, supported by Gigabit
devices). The default is Auto, which is usually not required to be modified, and if there is any
compatibility issue, or the device used does not support auto negotiation function, then the
type of Ethernet negotiation can be set up here.
Tip:
After modifying the LAN IP address, you must use a new IP address to log into the device, and the
IP for logging into the host must be on the same network segment!
6.4 DHCP server
This section mainly introduces the Network parameters -> DHCP server page, including DHCP
server settings, static DHCP and DHCP automatic binding and DHCP client list.
6.4.1 DHCP server configuration
Below is a description of the parameters for configuring the DHCP server functions.
To Next Page
Loading...
