Chapter 7 Advanced Configuration
http://www.level1.com Page 54
Figure 7_13 Policy routing configuration
Interface: Sets the physical interface bound by the policy routing, and the packets that meet
the conditions of policy routing will be forwarded from the bound interface.
Policy route name: Customizes the name of the policy.
Source address: The source IP address of the packets following this policy route, which can
be configured in two ways.
Network segment: The starting IP address and the ending IP address following this
policy route.
User group: The user group following this policy route, click on "User group" to refer to
the source address for policy reference for the user group. Enter User management ->
User group configuration-> Add new entry to set up the source address field for the
policy routing to take effect.
Destination address: The destination address in the packet following this policy route, which
is configured in the same way as the source address.
Services: The services in the packets following this policy route, which can be configured in
the following manner.
Ports: Range 1-65535, the corresponding protocols are TCP and UDP; when the selected
To Next Page
Loading...
