3-18 Service Manual
5025-2xx, 4xx
Printer Setup
Defaults
US/Non-US defaults changes whether the printer uses the US factory defaults or the non-US factory defaults.
The settings affected include paper size, envelope size, PCL symbol set, code pages, and units of measure.
Warning: Changing this setting resets the printer to factory defaults, and data may be lost. It cannot be undone.
To change the Defaults:
1. Select Printer Setup from Diag Menu, and press Select ().
2. Select Defaults, and press Select ().
3. Select U.S. (default) or Non-U.S., and press Select ().
Press Back (
) to return to Printer Setup.
Page counts
You can view but not change any of the three counts.
To view the Prt Color Pg Count, the Prt Mono Pg Count, or the Perm Page Count:
1. Select Printer Setup from Diag Menu, and press Select ().
2. Select the page count you wish to view:
• Prt Color Pg Count
• Prt Mono Pg Count
• Perm Page Count
3. Press Select ().
The value of the page count displays.
Press Back (
) to return to Printer Setup.
Serial Number
The serial number can only be viewed, but cannot changed.
To view the serial number:
1. Select Printer Setup from Diag Menu, and press Select ().
2. Select Serial number, and press Select ().
The Serial Number is displayed.
Press Back (
) to return to Printer Setup.
Engine Setting 1 through 4
Warning: Do not change these settings unless requested to do so by your next level of support.
Model Name
The model name can only be viewed and cannot be changed.
To Next Page
Loading...
Need help?
General
