Lexmark MS31x/41x/510/610 & MX310/410/51x/61x Product Study Guide Rev 1.3
Key Updates
Multipurpose Feeder (MPF) Tray Design
• The MPF tray for this printer series also uses the lift plate
mechanism.
• It can now hold up to a maximum of 100 sheets of media.
• The bail and pick tire cover are new FRU parts that will help
improve customer’s experience using the MPF tray.
MPF Pick Mechanism
• Now uses the Friction Separator Architecture.
• Parts included in the assembly are the following: D-roll, Idle
Rollers, Separator Housing, Flag Shaft, Frame-Upper Top
Assembly
Input Option: Improved Tray Design
• For this series, the optional input trays now have FRU parts
unlike the E series printers. With this new design, you don’t
have to replace the whole optional input tray when only the
ACM or pick roller assembly is broken or needing
replacement.
• A single optional tray is supported on the MS/MX310 &
MS/MX410 models. Any combination of 550- and 250-sheet
trays may be installed up to a total of 3 optional trays on the
MS/MX510 and MS/MX610 models.
Output Option: Staple Finisher (MX61x only)
• The Staple Finisher is a compact, modular, finishing
solution which offers single-position stapling for A4, letter,
legal, Folio and Oficio paper sizes, stapling from 2 sheets to
20 sheets per set (20 lb., 75 g/m
2
).
• It has staple low/empty sensor to indicate when the staple
supply is low as well as when staples run out. The staple
cartridge contains 1,000 staples.
• It does not have a dedicated output bin; it shares the same
output bin as the base printer.
• It has its own power supply which is designed to be a
customer installable part.
For Training Purposes Only 10 4/21/2014
To Next Page
Loading...
