Lexmark MS31x/41x/510/610 & MX310/410/51x/61x Product Study Guide Rev 1.3
Imaging Unit Life Messaging
The following table provides the messaging that will appear on the Control Panel as supply life becomes
low. Below the table, explanations are provided for the headings and options listed in each column.
Life Cycle
Default
Control Panel Message
Default Trip
1
Behavior Options
Nearly Low Disabled Imaging unit nearly low [84.xy]
100K = 10%
Off
Warning
E-mail alert
Continuable stop
Non-continuable stop
Low Enabled Imaging unit low [84.xy]
100K = 5%
Off
Warning
E-mail alert
Continuable stop
Non-continuable stop
Near End
of Life
Enabled
Imaging unit very low
[X]
3
estimated pgs remain [84.xy]
Page by page countdown begins.
100K = 1%
Off
Warning
E-mail alert
Continuable stop
Non-continuable stop
End of Life
Device Stops
Enabled
Replace imaging unit,
0
3
estimated pgs remain [84.xy]
0%
Non-continuable stop
1
This column indicates the default Imaging Unit life remaining. Once the Imaging Unit reaches this percentage, it will trigger the
given warning. The user can change the level that will trigger the warning. The procedures to do this are documented in this
guide in the section called “How to Change Supply Life Messaging Settings.”
2
This column lists the default behavior options at each warning notification. The customer can customize this feature. The
default behavior is documented in blue if no change is made.
3
The estimated number of remaining pages is based on recent printing history of the printer. Its accuracy may vary significantly
and is dependent on many factors, such as actual document content, print quality settings, and other printer settings. The
accuracy of the estimated number of remaining pages may decrease when actual printing consumption is different from the
historical printing consumption. Consider the variable level of accuracy before purchasing or replacing supplies based upon the
estimate. Until an adequate print history is obtained on the printer, initial estimates assume future supplies consumption based
on the International Organization for Standardization* test methods and page content.
*Average continuous black declared cartridge yield in accordance with ISO/IEC 19752.
For Training Purposes Only 55 4/21/2014
To Next Page
Loading...
