Lexmark MS31x/41x/510/610 & MX310/410/51x/61x Product Study Guide Rev 1.3
Restore Point
Restore point is a new functionality similar to a PC’s operating system restore. In the event that a new
firmware update causes problems in the printer, the administrator or customer can roll the printer back to
a previous state. All code is restored (RIP, Engine, etc.).
If restore point is used, you can “undo” the restore by holding the POR key sequence again.
4.3”and above
Touchscreen
Code level of EC1
and higher
To go to the Restore Point, do the following:
1. Turn off the printer.
2. Press and hold 7 and 8.
3. Turn on the printer.
4. Release the buttons when the
splash screen appears.
Important Information:
• Subsequent POR's boot to this
restore point.
• If new code is flashed, that new
code becomes the boot point.
• Only 1 restore point is kept.
• If no code updates have occurred
since the machine was built, there is
no restore point and the key
sequence is ignored.
• Only available on eTask machines.
For Training Purposes Only 71 4/21/2014
To Next Page
Loading...
