Lexmark MS310

Lexmark MS31x/41x/510/610 & MX310/410/51x/61x Product Study Guide Rev 1.3
Maintenance Items
Only available for the models indicated below:
MS510 and MS610
Item Approximate Yield
1
Customer Installable
Fuser
200, 000 No
ACM Pick Tires
200, 000 No
Transfer Roll
200, 000 No
MPF pick roller and separator pad
200, 000 No
Redrive Assembly
200, 000 No
Separator Roll Assembly
200, 000 No
1
The fuser may reach a life of up to 200,000 pages, based on an average of 3 pages per job and
approximately 5% coverage. Because these modules are affected by environment, duty cycle and
toner coverage, actual page count may vary.
MX310, MX410, MX51x and MX61x
Item Approximate Yield
1
Customer Installable
Fuser
200, 000 No
ACM Pick Tires
200, 000 No
Transfer Roll
200, 000 No
MPF pick roller and separator pad
200, 000 No
Redrive Assembly
200, 000 No
Separator Roll Assembly
200, 000 No
1
The fuser may reach a life of up to 200,000 pages, based on an average of 3 pages per job and
approximately 5% coverage. Because these modules are affected by environment, duty cycle and
toner coverage, actual page count may vary.
Notes:
• Maintenance kit alerts are based on printer NVRAM page count or fuser revs counter, whichever
hits the limit first.
• Page count limit is 200K pages, fuser rev limit is 2.2 million revs
• To reset maintenance kit counters, boot printer into Configuration Mode (press and hold 2 and 6
during printer power on) and select “Reset Maintenance Counter”.
• There are no hard stops for maintenance kit alerts for this printer series.
For Training Purposes Only 61 4/21/2014