Sensor (tray 1 media out) removal
1 Remove the right cover. “Right cover removal (MX71x)” on page 311.
2 Remove the rear lower door. See “Rear lower cover removal” on page 309.
3 Remove the LVPS. See “LVPS removal” on page 403.
4 Remove the left cover. See “Left cover removal (MX71x)” on page 301.
5 Remove the PCBA housing. See “PCBA housing removal” on page 394.
6 Remove the media tray. See “Media tray removal” on page 374.
7 Remove the pick roller assembly. See “Pick roller assembly removal” on page 377.
8 Remove the media feeder. See “Media feeder removal” on page 393.
9 Disconnect the cable (A) from the sensor (tray 1 media out).
7463
Repair information
379
To Next Page
Loading...
