Diagnostic information 2-69
4060-xxx
Main fan service check
Check the cable connections at J7 on the system board and at the main fan assembly. The main fan
runs continuously when the printer is powered on unless the printer is in the Power Saver mode.
FRU Action
1 Main fan Manually spin the fan and check that it rotates freely. Check the cable
connection to the system board, J7 for correct installation.
2
Main fan to system board
cable
Check the continuity of the cable. If incorrect, replace the cable.
3
Error code 927 (fan runs) Check the voltage at J7-1 on the system board. The voltage
measures +5 V dc (static) 0 V dc (fan running). If incorrect, replace
the main fan. If this does not fix the problem, replace the system
board.
4
Error code 927
(fan not running)
Check the voltage at J7-3 on the system board. The voltages are:
• +22 V dc to +24 V dc
(printer and fan running)
• +12 V dc to +15 V dc
(printer not running—fan running about half speed).
If incorrect, replace the system board. If this does not fix the problem,
replace the main fan.
To Next Page
Loading...
