4-6 Service Manual
4060-xxx
Screw identification table
The following table contains screw types, locations, and quantities necessary to service the printer.
Each screw callout in the removal procedure graphic displays the screw reference number listed in
the table. Pay careful attention to each screw type location when doing removals. You must install the
correct screw type in each location during reassembly.
Reference
number
Screw type Location Purpose Qty
M3.5x8 mm Thread
Cutting
right side frame to center pan attach 1
toner level sensor mounting 1
charge roll bracket mounting 1
main drive gearbox mounting 3
EP module to left and right side frame attach 9
developer drive assembly mounting 2
stacker duct to frame mounting 2
cartridge hold down assembly mounting 2
MPT deflector mounting 2
laser cover mounting 4
deflector mounting 2
spring mounting 1
system board mounting
(front)
2
integrated tray (ITC) board mounting 1
stacker support to right side frame attach 2
M3.5x12 mm
Thread Cutting
paper alignment assembly mounting 2
toner cartridge guide track mounting 2
left side frame to center pan attach 3
right side frame to center pan attach 2
deflector mounting 2
M3x5 mm Taptite INA cover
(2 screws per cover)
attach 6
To Next Page
Loading...
