Lexmark T632 - Developer Drive Assembly Removal; Frames Removals; EP Frame Assembly; Left Side Frame

4-20 Service Manual
4060-xxx
Developer drive assembly removal
1. Remove the inner shield. See “Inner shield removal” on page 4-34.
2. Remove the developer drive assembly mounting screws (A).
3. Remove the developer drive assembly.
Note: Be sure the developer drive shaft and coupler aligns with the hub on the main drive assembly
when reinstalling the assembly.
Frames removals
EP frame assembly
1.
Remove the left and right side frames. See “Left side frame” on page 4-20 and “Right side
frame” on page 4-22.
2. Remove the EP frame assembly.
Left side frame
1. Remove the covers.
2. Remove the inner shield. See “Inner shield removal” on page 4-34.
3. Remove the main drive assembly. See “Main drive assembly removal” on page 4-44.
4. Remove the upper front cover hinge assembly. See “Upper front cover hinge assembly
removal” on page 4-62.
5. Remove the multipurpose tray/lower deflector assembly.