2-32 Service Manual
4060-xxx
User line 2 link messages
If the printer is locked on a particular link, the link indication displays. If the printer is ready to process
any link, no messages display. Link messages are listed in the following table.
280 Paper Jam
Check Finisher
Leave Job in Finisher Primary: Paper is jammed in the finisher option. Open
the finisher option side door or top cover to access the
jammed pages.
Secondary: When this message is displayed, do not
remove accumulated sheets during the jam clearance
procedure as the printer will not reprint the removed
sheets. Also, if the accumulated sheets are removed,
the portion of the job printed after the jam will not be
stapled.
281 Paper Jam
Check Finisher
Remove Job from
Finisher
Primary: Paper is jammed in the finisher option. Open
the finisher option side door or top cover to access the
jammed pages.
Secondary: When this message is displayed, remove
the job from the finisher. The printed will not reprint the
removed sheets.
282 Staple Jam
Check Stapler
Remove Job from
Finisher
Primary: A staple jam has been detected during
normal stapler operation.
Secondary: The printer flashes the secondary
message to indicate that all accumulated sheets
should be removed during the jam clearance.
283 Staple Jam
Check Stapler
A staple jam has been detected during the priming
operation.
Note: Press Go to initiate priming and resume printing
while either of the primary or secondary messages
displays.
1565 Emul Error
Load Emul Option
This message appears when the IPDS emulation
version contained in the SIMM does not function with
the printer code. This message automatically clears in
30 seconds, and the IPDS emulation is disabled. No
other printer functions are affected. The correct IPDS
emulation must be downloaded.
User message Explanation
Parallel Standard Parallel Port, if available.
Serial Standard Serial Port, if available.
Serial x Serial Port is attached to PCI connector x, where x=1, 2, or 3.
Network x Network card x is attached to PCI connector x, where x=1, 2, or 3.
LocalTalk x LocalTalk Card x is attached to PCI connector x, where x=1, 2, or 3.
Infrared Standard Infrared port, if available.
Infrared x Infrared Port x is attached to PCI connector x, x=1, 2, or 3.
User attendance messages (continued)
Primary message Secondary message Explanation
To Next Page
Loading...
