4-30 Service Manual
4060-xxx
Fuser transfer plate removal
1. Remove the upper paper deflector. See “Upper paper deflector assembly removal” on
page 4-63.
2. Remove the transfer roll.
3. Remove the inner paper deflector. See “Inner paper deflector assembly removal” on
page 4-33.
4. Lift the left side of the fuser transfer plate (A) and move the plate to the left to clear the right side
from its mounting.
5. Remove the screw that attaches the transfer plate ground wire to the center pan.
6. Remove the fuser transfer plate.
7. Remove the screw that attaches the deflector cable to the transfer plate.
A
To Next Page
Loading...
