4-40 Service Manual
4060-xxx
Interconnect board assembly removal
CAUTION: Unplug the printer before you begin.
Warning: Observe all ESD precautions while handling ESD-sensitive parts. See “Handling ESD-
sensitive parts” on page 4-1.
Note: Any time the interconnect board assembly is replaced, the Configuration ID must be reset in
NVRAM on the new interconnect board. Go to “Setting configuration ID” on page 3-18.
1. Remove any feature or option cards from the interconnect board.
2. Remove the inner shield. See “Inner shield removal” on page 4-34.
3. Remove the LVPS access plate and disconnect the LVPS cable from CN2 (A).
4. Disconnect cables J4 and J5 from the interconnect board.
A
To Next Page
Loading...
