Lexmark T632 - Sub Error Codes; Sub Error Codes for 9 Xx and 2 Xx Error Codes

Diagnostic information 2-5
4060-xxx
Sub error codes
Sub error codes for 9xx and 2xx error codes
The sub error codes are helpful troubleshooting a paper path problem, especially paper jams in the
base printer, envelope feeder, and duplex option.
Displayed error codes
When a 9xx or 2xx error displays:
1. Press and hold Return and press Select to enter for sub error codes.
The first screen of information displays. Write down the information.
2. Continue pressing Return and Select until each screen of information is obtained.
3. When the last screen displays, the original message displays.
The following is an example of how the printer displays a duplex option sub error code.
Printed error codes
Additional information is available by printing the error log. See “Printing the error log” on
page 3-7.
990 <device> Indicates an equipment check condition has occurred in the specified device, but
the device is unable to identify the exact component failure.
Note: <device> can be one of the following: duplex, tray x (1, 2, 3, 4, or 5),
envelope feeder or output bin.
991 <device> Card The specified device has detected an equipment check in its system card.
Note: <device> can be one of the following: duplex, tray x (1, 2, 3, 4, or 5),
envelope feeder or output bin.
DU
DU
Byte 1
xx
xx
Byte 5
Byte 2
xx
xx
Byte 6
Byte 3
xx
xx
Byte 7
Byte 4
xx
xx
Byte 8
Service error code (continued)
Error code Action