4-50 Service Manual
4060-xxx
Operator panel cable removal
Note: Pay careful attention to the cable routing through the printer before you remove the operator
panel cable.
1. Remove the left cover. See “Left door removal” on page 4-9.
2. Remove the upper front cover. See “Upper front cover removal” on page 4-12.
3. Remove the outer system board shield. See “Outer shield removal” on page 4-52.
4. Disconnect the operator panel cable from connector J15 on the system board.
5. Remove the operator panel. See “Operator panel assembly removal” on page 4-48.
6. Remove the cable retainer from the left side of the upper front cover hinge assembly.
Note the routing of the operator panel and cover closed switch cables.
7. Remove the old cable from the printer.
8. Plug the new operator panel cable into the operator panel.
9. Snap the operator panel into the upper front cover.
To Next Page
Loading...
