4-18 Service Manual
4060-xxx
Communications board removal
1. Remove the outer shield. See “Outer shield removal” on page 4-52.
2. Remove features and options from the interconnect board only if they block access.
Warning: Observe all ESD precautions while handling ESD-sensitive parts. See “Handling
ESD-sensitive parts” on page 4-1.
3. Remove the communications board mounting screw (A).
4. Remove the communications board shield mounting screw (B).
5. The communications board is held in place by a ground clip (C) on the shield that attaches the
communications board shield to the side frame. Pull the board up to unclip the shield.
6. Remove the screws that hold the shield to the communications board.
Note: Retain the shield and screws to install on the new board.
C
A(232)
B(201)
To Next Page
Loading...
