4-42 Service Manual
4060-xxx
Low voltage power supply removal
CAUTION: Unplug the printer before you begin.
1. Remove the right side cover. See “Right cover removal” on page 4-10.
2. Remove fuser assembly. See “Fuser assembly removal” on page 4-23.
3. Remove the LVPS mounting screws (A) from the rear of the bottom pan.
4. Pull the LVPS assembly far enough out from the right side of the printer to disconnect the fuser
lamp cable.
Warning: The LVPS assembly may be difficult to remove from the printer. Do not use
excessive force in the removal.
A(203)
To Next Page
Loading...
