2-18 Service Manual
4060-xxx
The flash memory is being formatted. No button actions are possible while
this message displays.
The flash memory is being
programmed, which means fonts or
macros are being written to flash
memory.
Do not perform any button actions
while this message displays.
The disk is being formatted. No button actions are possible while
this message displays.
The disk is being programmed, which
means fonts or macros are being written
to disk.
No button actions are possible while
this message displays.
Note: If information is written to flash
memory and to disk at the same time,
the Program Flash message displays.
The printer menus have been disabled.
This occurs when Menu is pressed
while the printer is Ready and Menu
Lockout is active. The printer display
shows this message for one second and
then returns to the Ready message.
No button actions are possible while
this message displays.
The printer is reset to activate a printer
setting changed in the menus.
No button actions are possible while
this message displays.
User status messages Status Action
Formatting Flash
(Do Not Power Off)
Program Flash
(Do Not Power Off)
Formatting Disk
Programming Disk
(Do Not Power Off)
Menus Disabled
Activating Menu Changes
To Next Page
Loading...
