Link4 iPonic 624 - Programming Instructions

iPonic 624® Manual PN 995-1124-00
19| Page
In this Example:
Setpoint 1 is set to 8:00 a.m. with a 60 minutes Ramp, Temp is set as 68 to 72.5F
Setpoint 2 is set to 6:00 p.m. with a 30 minutes Ramp, Temp is set as 67 to
70.5F
Programming Instructions
Before programming the iPonic 624 controller, make sure the equipment has been
properly connected and tested with the Manual Override Switches. After all
equipment is tested, the switches must be placed back to the AUTO position.