Basic Setup4
F. Tap Save.
5. Enter a new, secure 8-15 character password. This password will be used to connect to your
system from now on.
6. Your cameras will appear on the Live screen of the app. Tap the play button (
) to stream
live video on channels that are in sleep mode.
NOTE
If you do not see video from one or more cameras, ensure you have removed the PLEASE REMOVE label
from the Power Pack. If the issue persists, see , page .
4.4 STEP 4: Installing the Cameras
4.4.1 Installation Tips
Follow the tips below for more accurate motion detection and to optimize battery life:
• See images below for ideal setup. It is recommended to place your camera at least 7ft (2.1m)
above the ground and angle it slightly downward toward the monitoring area, excluding any
busy areas (e.g., sidewalks or roadways).
• Ensure the camera image is free of obstructions (i.e., tree branches).
• Position the camera no more than 20ft (6.1m) away from the area you wish to monitor.
• Ensure you have configured the active area for motion detection so that only areas of interest
are selected. It is recommended that you customize motion settings for each camera on your
system. See 4.4.3 Optimizing Motion Detection, page 14 for full details.
• For best performance, position the camera so that objects of interest will move from side-to-
side across the camera image, rather than moving towards or away from the camera.
• Install the camera within range of the wireless receiver (noted in the camera’s specifications).
• This camera is weather resistant for outdoor use (IP66 rated). Installation in a sheltered location
is recommended.
• Battery life will vary based on temperature, settings and number of events.
4.4.2 Installing the Cameras
Follow the instructions below to mount the cameras. It is recommended that you refer to the "In-
stallation Tips" section to help you select good mounting locations (see 4.4.1 Installation Tips,
page 11).
To install your cameras:
#LX400109; r. 2.0/54857/55689; en-US 11
To Next Page
Loading...
Need help?
General