Active Deterrence13
5. Click Set next to Area to set an active area for automatic deterrence.
• The camera image appears with a grid overlay. The green area is the active area for
deterrence.
• Click or click-and-drag to add / remove boxes from the active area.
• In the example image above, only motion around the garage or on the porch will trigger the
warning light.
• Right-click when finished.
6. Click Set next to Schedule to set the weekly schedule for automatic deterrence.
• Click or click-and-drag along each of the yellow timelines to quickly add or remove time
from each day’s schedule in 15–minute segments.
• Click
beside 2 or more days to link schedules ( ). This allows you to quickly
change multiple schedules at once.
• To make fine adjustments to a schedule, click Set. This will allow you to set exact start and
end times for a schedule.
• Click OK when finished.
7. Configure preferences for the warning light:
• Duration: Choose how long the warning light will stay on when motion is detected.
• Select Warning Light for a solid white light, or Strobe for a flashing light. If you select
Strobe, set how quickly the light will flash under Strobe Frequency.
#LX400113; r. 1.0/56015/56022; en-US 46
To Next Page
Loading...
Need help?
General