Using the Main Menu16
3. Check Enable.
4. Select Trusted Sites to add IP addresses or ranges that are permitted to access the recorder, or
select Blocked Sites to add IP addresses or ranges that are not permitted to access the recorder.
5. Click Add to enter an IP address or range.
6. Click Apply when finished.
16.4.4 Configuring Email Alerts
You can configure the system to send out email alerts for motion detection or other events.
NOTE
To send out motion detection alerts, you must enable the Send Email option for motion detection on each camera
you would to receive alerts from. For details, see 12 Motion Detection, page 42.
To configure Email Alerts:
1. From the Live View display, right-click to open the Quick Menu, then click Main Menu.
2. Click
, then click NETWORK. Click the EMAIL tab on the side panel.
3. Check Enable to enable email notifications.
If you want to use Lorex’s email server (recommended):
1. Under Mail Select, select Lorex Mail to use the Lorex email server to send out alarm notifica-
tions. This is the recommended setting.
#LX400113; r. 1.0/56015/56022; en-US 77
To Next Page
Loading...
Need help?
General