Smart Motion Detection14
4. Configure the following:
• Enable: Check Person or Vehicle or both to enable each type of smart detection.
• Area: Click Set under each detection type you have enabled to set the active area for
detection.
◦ Click Add to set an area for person or vehicle detection on the selected channel. Click-
and-drag the corners to resize the area.
◦ For most accurate results, set an area where objects of interest will move within the
bounding box as well as into / out of.
◦ Check Light next to a rule to flash the camera’s warning light when an object is
detected.
◦ See 14.1 Ensuring Accurate Person & Vehicle Detection, page 48 for optimal camera
positioning for person and vehicle detection.
• Schedule: Click Set under each detection type you have enabled to set the weekly schedule
for detection.
5. If you choose to flash the camera’s warning light when a person or vehicle is detected, config-
ure the following warning light options:
• Duration: Enter the time in seconds the warning light will remain on after a person or ve-
hicle is detected.
• Warning Light / Strobe: Choose Warning Light to use a solid white light, or Strobe for
a flashing light. If you select Strobe, choose the Strobe Frequency to determine how
quickly the warning light will flash when triggered.
#LX400113; r. 1.0/56015/56022; en-US 50
To Next Page
Loading...
Need help?
General