Chapter 5 XGT Panel Menu Explanation
(2) General
Mouse cursor does not appear after scrolling.
You can set whether buzzer is used or not.
Low Memory Mode XGT Panel starts monitoring the images used on the screen to speed up the screen
operation.
It will be loaded into memory before use. By the way,
If a positive image is used, due to memory space constraints, all
The image will not load. In this case, if the screen is not yet loaded
Images are loaded, and there is not enough space, so unused images are retrieved from
memory
The operation to delete may be repeated, and the screen switching operation may be
slowed down. In this situation
Low Memory Mode "is recommended. In Low Memory Mode, you do not load the image
before monitoring, but use only the original source of the image used in the project, which
results in less memory usage and less load to load and delete images into memory.
Reset USB power
after boot up
When XGT Panel starts, it turns off USB power On to initialize the connected device.
The initial setting is On, and if the USB recognition speed is slow or not well recognized
Uncheck, power on again and try again.
And data files
Delete all files you've downloaded on your device. However, connecting to the device
If a password is set, you must enter the password before you can delete it. The password
is the device connection password that you enter when downloading a project, This can
be set in XP-Builder on the Device Information View tab of the Communication dialog box.
The files to be deleted include user project data, web server, VNC startup module, option
card Driver, RAPIEnet communication setting data, XP-Manager setting data etc. from
user PC All downloaded data is included. Set using the configuration menu of the
machine. The contents are kept uninitialized. If the menu language is not English,
A device reboot is required to delete files.
To Next Page
Loading...
Need help?
General