LSIS XEC-DR32H - Page 135

Chapter 8 Built-in High-speed Counter Function
■ In order to output the compared output signal, compared output enable flag set to ‘1’ after
compared output condition set.
Classification
Area per channel
Operation
Ch. 0 Ch. 1 Ch. 2 Ch. 3 Ch. 4 Ch. 5 Ch. 6 Ch. 7
Count enable
signal
%KX4160 %KX4320 %KX4480 %KX4640 %KX34880 %KX35040 %KX35200 %KX35360
0:disable, 1:
enable
Compared 0
enable signal
%KX4164 %KX4324 %KX4484 %KX4644 %KX34884 %KX35044 %KX35204 %KX35364
0: disable, 1:
enable
Compared 1
enable signal
%KX4167 %KX4327 %KX4487 %KX4687 %KX34887 %KX35047 %KX35207 %KX36367
0: disable, 1:
enable
■ In order to make external output, the compared coincidence output signal (P20~P2F) must
be set. If Compared output contact is ‘Off’ at Special Module Parameter Setting of XG5000,
Compared coincidence output signal (internal device) is only output.
Classification
Area per channel
Operation
Ch. 0 Ch. 1 Ch. 2 Ch.4 Ch.5 Ch. 6 Ch.7
Compared coincidence
output signal 0
%KX4178 %KX4338 %KX4498 %KX4658
%KX3489
8
%KX3505
8
%KX35218
0: Compared output Off
1: Compared output On
Compared coincidence
output signal 1
%KX4179 %KX4339 %KX4499 %KX4659
%KX3489
9
%KX3505
9
%KX35219
0: Compared output Off
1: Compared output On
• Comp. output point (%QX0.0.0 ~ %QX0.0.15) setting
8-11