LSIS XEC-DR32H User Manual

Chapter 8 Built-in High-speed Counter Function
Chapter 8 Built-in High-speed Counter Function
XGB series have built-in function of High-speed counter in main unit. This chapter describes specifications
and usage of High-speed counter’s function.
8.1 High-speed Counter Specifications
 It describes specifications, setting and usage of function, programming and wiring with external
device of built-in main unit.
8.1.1 Performance specifications
(1) Performance specification
Classification Description
Count input
signal
Signal
A-phase, B-phase
Input type
Voltage input (Open collector)
Signal level
DC 24V
Max. coefficient speed
100kpps
Number of
channels
1 phase
8 channels
100kpps (ch0,1,2,3) / 20kpps (ch4,5,6,7)
※1
2 phase 4 channels
50kpps (ch0,2) / 10kpps (ch4,6)
※1
But, In case of 4 multiplication: 50kpps (ch0,2) / 8kpps (ch4,6)
Coefficient range
Signed 32 Bit (-2,147,483,648 ~ 2,147,483,647)
Count mode
(Program setting)
Linear count (if 32-bit range exceeded, Carry/Borrow occurs)
Counter max. and min. value is indicated
Ring count (repeated count within setting range)
Input mode
(Program setting)
1-phase input
2-phase input
CW/CCW input
Signal type
Voltage
Up/Down
setting
1 phase input
Increasing/decreasing operation setting by B-phase input
Increasing/decreasing operation setting by program
2 phase input
Automatic setting by difference in phase
CW/CCW
A-phase input: increasing operation
B-phase input: decreasing operation
Multiplication
function
1 phase input
1 multiplication
2 phase input
4 multiplication
CW/CCW
1 multiplication
Control input
Signal
Preset instruction input
Signal level
DC 24V input type
Signal type
Voltage
External output
Output points
1 point/channel (for each channel)
:output contact point of main unit available
2 point/channel (for each channel)
:output contact point of main unit available
Type
Select single-
compared (>, >=, =, =<, <) or section compared output (included or
excluded) (program setting)
Output type
Relay, Open-collector output (Sink)
Count Enable To be set through program (count available only in enable status)
Preset function
To be set through terminal (contact) or program
Auxiliary mode (program setting)
Latch counter, Count per unit time (time setting value: 1~60,000ms)
8-1

LSIS XEC-DR32H Specifications

General

Brand	LSIS
Model	XEC-DR32H
Category	Controller
Language	English