WARNING!
Read Me First!
READ THIS MANUAL COMPLETELY BEFORE UNPACKING AND
POWERING UP YOUR PRINTER.
Hazards and Warnings
The TAZ 3D printer has motorized and heated parts. When the printer is
in operation always be aware of possible hazards.
Electric Shock Hazard
Never open the electronics case when the printer is powered on. Before
removing the electronics case cover always power down the printer and
completely turn off and unplug the power supply and allow the power
supply to discharge for at least 1 minute.
Burn Hazard
Never touch the extruder nozzle or heater block without first turning off the
hot end and allowing it to completely cool down. The hot end can take up
to twenty minutes to completely cool. Also, never touch recently extruded
plastic. The plastic can stick to your skin and cause burns. Also beware
of the heated bed which can reach high temperatures capable of causing
burns.
Fire Hazard
Never place flammable materials or liquids on or near the printer when
powered or in operation. Liquid acetone and vapours are extremely
flammable.
Pinch Hazard
When the printer is in operation take care to never put your fingers in the
moving parts including the belts, pulleys, or gears. Also, tie back long hair
or clothing that can get caught in the moving parts of the printer.
x
To Next Page
Loading...
Need help?
General
