3.3. FIRST SLICE
Figure 3.14: Simple Mode: Printer Settings.
Size and coordinates.
The
Bed size
setting is taken from the wizard
(see p.43) and is only used for previewing the model in the plater.
The
Print center
is the point around which the print will be centered.
A
Bed size
of 200mmx200mm and a
Print center
of 100mmx100mm
would sit the print in the middle. Should it be desired to print away from
the center, because of a scratch in the glass perhaps, then this option should
be used.
57
To Next Page
Loading...
