3.4. EXPERT MODE
Figure 3.21: Infill pattern settings.
Slic3r offers several infill patterns, four regular, and three more exotic
flavours. The numbers given in brackets below each figure are a rough
estimate of material used and time taken for a simple 20mm cube model
14
.
Note that this is only indicative, as model complexity and other factors will
affect time and material.
Figure 3.22: Infill pattern: Line (344.51mm / 5m:20s)
Figure 3.23: Infill pattern: Rectilinear (350.57mm / 5m:23s)
14
Taken from http://gcode.ws
69
To Next Page
Loading...
