Your First 3D Print
5.5 Remove Part
After the part is finished printing, the heated bed will automatically cool
down to
0
◦
C
. Once the bed cools you can you pop the finished part off of
the printed surface. To remove the printed part, use the clam knife included
in your printer kit. Leather gloves are suggested to protect your hands from
the clam knife blade. It is also safe practice to not place your hand behind
the direction you are pushing the clam knife. Using the side of the clam
knife blade pry up one side of the printed part. If your part is large you
may need to pry at multiple points to pop the part off of the print surface.
When removing parts take caution to not damage the PET film. If the film
is cut or ripped it will peel from the glass and need to be replaced. Make
sure to reset the heated bed to the correct temperature and allow it to heat
up to the needed temperature before starting the next print.
96
To Next Page
Loading...
